Racing sim update

Some time ago I somewhat shelved the sim, mostly because I didn’t really have the room to keep it set up but also because I decided to re-work the wheel setup but it never really took off.  The idea was to make my own electric feeback wheel with an optical encoder, arduino and a big DC motor but I could not get it right.  The movement side of it was fine – I had the arduino reading the pulses and converting this into a joystick axis but it was the electric force where I could not get it right. Big DC motor, H-Bridge and PWM but I could not get enough force out if it that I was happy with.  I decided the best option was to buy a commercial wheel and use my pedals/shifter.
I ended up buying a Logitech G27.  I am very happy with the mechanics of the wheel and it’s force abilities but the pedals and shifter really let it down. I tried them but going back to a position type brake (over force like my pedals) just felt all wrong and while the shifter is ok, it just did not have that realism of my DIY aluminium H shifter.
I also removed the stock wheel from the G27 and replaced it with the one from my other setup and placed some button switches on the wheel to hook up in place of the stock ones.  This is a much better size and feel.  The only downside is the flappy paddles are now too short but I hardly ever use them. Maybe one day i will make up some longer ones.
I have re-worked my H shifter now too.  As well as replacing the H plate with a friendlier soft plastic (cutting board) instead of the aluminium I had before I have modded it to be able to swap to sequencial mode. This is great for RBR and other rally games but I also prefer it to paddles where it is harder to change gear while turning.
There is now an extra 2 switches mounted to the bottom of the H plate and a removable washer is screwed to the bottom of the shifter shaft.  This gives a little extra throw on the shaft to push the switches.  I also too advantage of the holes in the upper part of the shifter to insert some tube to restrict the movement forwards and backwards.  This restriction allows the shifter to return to center.  Another screw in one of the brackets supporting the shifter prevents sideways movement too.
Swapping from H to sequencial takes about 30 seconds and is very easy.

Leave a Reply